Quote:
Originally Posted by RoaringV8
Installed the LT2 intake and Roto-Fab Sound Tube Delete CAI on my SS 1LE this weekend. I'm also using the LT5 TB with the Soler 95 to 87MM TB adapter. Ordered the LT2 intake from GPI with the appropriate fitment mods. Retained most of the foam aside from the section over the fuel pump. Slid in and bolted down pretty nicely. For those of you with the strut tower brace, I used 5/16 washers (3), which I bought from Home Depot, under each bolt to help raise it up to clear the top of the Intake Manifold. Two washers worked, but it was still a little too close for my liking. I also purchased (2) M8 1.25 x 30MM. I believe the stock bolts on the strut tower are 1.25 x 20MM which is too short when you add in the washers.
|
Is the intake side of the 95 mm throttle body the same diameter regarding the intake tube and seal that clamp to it.