Quote:
Originally Posted by BanOne
How are the inside skirts attached? I assume drilled. Just wondering how.much and if I could install myself.
|
The ACS ones are drilled then rivited, and very snug without ANY sagging or gaps. You just use a few simple clamps to hold them in place, then drill into the car's rockers through the existing holes on the skirts and pop in like 20ish rivets on each side. Took me a little over an hour to do both sides with the car on jack stands and including a beer break. Wrap some masking tape around the drill bit (or use a drill bit stop) to prevent from drilling too far into the car. ACS makes rock guards for the front that are moulded to fit their skirts too FTW.