[Junction65]

This thread comes up on a lot of "catch can" searches so I thought I would add my recent install info here. Hope it helps those that go with the Single Exit kit.

Purchased the Elite Engineering E2 can for the 2016+ Camaro with the Single Exit port. In addition to the catch can kit, I ordered 2 of the GM OEM Quick Disconnect fittings as well.

GM OEM Quick Disconnect Fitting - STRAIGHT

This video shows to how to attach the hoses to the can.
Install Hoses on Ferrule Fittings - Elite Engineering - Catch Can

Installation is pretty straight forward. I used the same "hot water" procedure to attach the 2 fittings to the hoses along with the supplied clamps. The fittings make it very easy to connect (and disconnect if need arises) the hoses to the engine and intake. All I had to remove was the driver side "Camaro" cover and then I could reach/disconnect the factory PCV tube and connect the catch can hoses. When mounting the catch can, there is a hard line (plastic hose) that runs right where the can sits. Move it to the side of the can (under the can mounting bracket) so as not to impede your ability to unscrew the can to dump the contents.