Too much lift on either for stock heads and rocker arms. I would personally keep the lift around .600 with stock style rocker arms. I don't understand why companies are producing these extra high lift cam shafts when valve guide scrubbing is a issue. It was a problem on LS and I don't see anything has changed to address it on LT. Now if you went with a ported head and roller rocker arms that maintains better geometry at higher lift then I could see either cam working well. Not to mention they are harder on lifters because you need stouter springs to control them.
So basically the cam above with a standard dual spring(btr platinum) and LS7 lifter is a recipe for valve-train failure within 20k miles.
Call kip at cam motion and tell him what you are looking to do.
__________________
2016 NFG 1SS A8
Options-2SS Leather/NPP
Perf. mods-Whipple 2.9/Fuel System/Flex Fuel/103mm TB/Rotofab Big Gulp/Cat Deletes/Corsa NPP
Per. times- 10.5 @ 137 w/ 1.8 60ft Full weight on 20's 1200DA
|