CAMARO6 - View Single Post - How To Fix Limited Seat Recline on 2016 Camaro

Jarek · 09-27-2022, 05:11 AM

Question - I am looking at the photos and position of the pin to drill and can't stop wondering - can all this be done without having to remove the seat? (removing the seat is the most difficult part - it is heavy, you can hurt yourself and of course you can damage the car)
What if you put it max to front and max up - you should have access from the side, right? If I am not wrong for the passenger seat you are drilling from the outside side.
Just disconnect the battery, then seat connector, remove the plastic covers, unzip the zipper and you should be ready to drill, correct?
Or am I missing something?

BR,
Jarek

09-27-2022, 05:11 AM	#35
Jarek Drives: 2017 2SS Convertible Join Date: Mar 2021 Location: Warsaw, Poland, EU Posts: 95	Question - I am looking at the photos and position of the pin to drill and can't stop wondering - can all this be done without having to remove the seat? (removing the seat is the most difficult part - it is heavy, you can hurt yourself and of course you can damage the car) What if you put it max to front and max up - you should have access from the side, right? If I am not wrong for the passenger seat you are drilling from the outside side. Just disconnect the battery, then seat connector, remove the plastic covers, unzip the zipper and you should be ready to drill, correct? Or am I missing something? BR, Jarek __________________ Camaro SS 2017 Convertible, 2SS trim, V8 6.2L 455HP 618Nm, A8, Silver Mods so far: K&N oil air filter, rear lamps EU conversion with sequential turn signal, exhaust modification to 4 tips (non-NPP), LED rear fog light (EU requirement), side-markers conversion to LED Mods planned: Morimoto LED lamps set (front) Last edited by Jarek; 09-27-2022 at 07:43 AM.