Quote:
Originally Posted by dmginc
we get a partial pic cause they didnt fit right?
|
Quote:
Originally Posted by insidethreat07
what kinda pic is that?
|
The kind where you realize that
A: Some exhaust kits require PHB relocators without realizing it
and
2) I is poor and can't weld 'em on yet.
Had it up in the air yesterday and in the least.. I've got fitment issues over the passenger side that's preventing the pipe from centering on the right side. Either hits the upper panhard bar mount or it hits the upper bar itself.
Less than an inch clearance all around (except toward the driveshaft..) So I either gotta pull the pipe end off the passenger out and bend it to gain an extra inch (therefore centering the tips) or I pull the drivers side in closer to the center of the fascia.
At least $120 shop time and a days worth of work to get it properly centered and not too close to anything (which is what would happen if we centered it as is). Could cost more but strictly shop time since that's all I'm paying for: Welding/Bending/Fitting/Extra 4 letter words.
Wut.