[Russell99]

Just a little information for those of you that want to add a subwoofer/amp to your stock non bose system.
I had read several threads and did several online searches to find some not so accurate information. First, my camaro has no amplifier, or no amplifier that I could locate therefore I could not use Steve at ********s awesome wiring harness for non bose systems with stock amp. I searched the trunk spare tire area as well as the trunk left and right panels. I pulled the rear quarter panel trims on each side of the back seat as well as the seat back and bottom.
In the spare tire area of the trunk was a fuse block and in that fuse block is a 30 amp fuse for an AMP. If there is an amp in my car it has to be in the front area of the car. So here is what I did and it was very easy.

1. Installed an AudioControl LC2i Line output converter. I T-Tapped into the rear left and rear right speaker lines and ran those speaker wires to the LC2i speaker level inputs. Hint (you do not have to remove the entire quater panels to reach and tap into the rear speaker lines. See Pics 1, 2 and 3 the key is to use the T-Taps..... no splicing or cutting the wires).

2. Installed an old Power Acoustik 4000 watt mono amplifier that I had ordered a long time ago and never used. The install of the amp was super easy since the battery on the camaro is in the back passenger side of the trunk. I removed the foam contraption that is in the spare tire area and installed both the amp and lc2i there. See pics 4, 5 and 6.

3. I purchase from Amazon the Uriveusa 12V Car Add-A-Circuit Fuse TAP Adapter Fuse Holder with 10A, 20A Fuse [Upgraded Fuses] - (2 Pack) (Micro2 Fuse). I unplugged fuse#55 the one that controls the radio and installed the add a circuit there. See pic 7. I had to slot the fuse box for the wire to run it to the LC2i. See pic 8.

4. Ordered 12" Solarbaric L7 sub and ported sub box from amazon (Ground Shaker) and installed through the back seat into position. See final pics of install.