Most people will be done here. The next part is for those with OCD
.
I noticed in the first photo that here is some distortion of the ring of text, specifically the word CAMARO. (This effect might not be noticeable with other graphic designs.)
The bottom of the door trim panel is not level with the ground!
Off it comes again.
I fashioned a clamp from a 3/8" bolt, nuts and fender washers. These will form a flat spot bigger than the hole when I use a heat gun to soften the panel from the inside. Then with gloves on, pull up on the bolt head while holding back at the arrows with the other hand, until it cools.
I should have gone a little more than I did here, but not bad for now.