CAMARO6 - View Single Post

dissonance · 05-21-2018, 11:50 PM

Thanks RXtacy! Beyond grateful for this. Curious, did you happen to check the clearance of the ARP studs with the knuckle before you removed the hub? I'd like to avoid removing the hub if I can and install the extended studs using the washer stack/impact method but I'm not sure if there is enough room behind it given the need for a steeper angle of install with the longer stud. Does that makes sense? I know for sure the 1" longer would be a no go without removing the hub, but I think I have a shot with 0.5" It looks so different depending upon the angle of the photo! I'd also be working on the 1LE setup. Thanks man!

05-21-2018, 11:50 PM	#16
dissonance Drives: '18 SS 1LE Join Date: Nov 2017 Location: Portland Oregon Posts: 4	Stud Clearance with Knuckle? Thanks RXtacy! Beyond grateful for this. Curious, did you happen to check the clearance of the ARP studs with the knuckle before you removed the hub? I'd like to avoid removing the hub if I can and install the extended studs using the washer stack/impact method but I'm not sure if there is enough room behind it given the need for a steeper angle of install with the longer stud. Does that makes sense? I know for sure the 1" longer would be a no go without removing the hub, but I think I have a shot with 0.5" It looks so different depending upon the angle of the photo! I'd also be working on the 1LE setup. Thanks man!