[bpang1234]

Whatever you do you need to pay huge attention to where you place the vents. I was watching a video the other day watching an engineer explain the good and bad places to place vents and the best location is basically where our stock ones are and where the 19's have their's placed...right at that distance from the front edge is where you need to place the vents to get the best flow out of the bay.

I have been slowly looking into using the stock vents and getting NACA ducts built in to increase the airflow out of them...the stock plastic air routing under the finisher plates is decent but not high flowing...a compromise between flow and not letting too much water into places they don't necessarily want a lot of water dripping to.

Did any of that make sense? It's late.