Quote:
Originally Posted by Shookem
I bought the DSXTuning Baro / IAT and I’m trying to figure out where to install the IAT Sensor. Is there a location for it or do I need to make a hole for it?
|
Kind of depends on what you are trying to measure with the new IAT sensor.
I am using one, and since I am using meth injection it is setup behind the throttle body in the intake to read the air temp after the meth is mixed with the air.
I just drilled and tapped my plastic intake for the thread on the temp sensor, sealed with 297 Loctite thread sealer and it was done.