Here you go. There are two flanges, one between the hat and the rotor (black arrow), plus another one (orange arrow) between that and the wheel mounting surface around the hub, see picture. I actually dug up my digital caliper for these two measurements, my garage cabinets and toolboxes are still not delivered, but that's another story, oh well.
This means there is a ~60-15.4-13.4 = ~31 mm gap between the caliper's edge and the wheel's mounting surface, I guess that's what your concern was...?
__________________
2018 Camaro 2SS — G7E MX0 NPP F55 IO6
735 rwhp | 665 rwtq
Magnuson TVS 2300 80mm pulley | Kooks 1 7/8" LT headers | JRE smooth idle terminator cam | LT4 FS & injectors | TSP forged pistons & rods
JMS PowerMAX | DSX flex fuel kit | Roto-Fab CAI | Soler 95mm LT5 TB | 1LE wheels | 1LE brakes | BMR rear cradle lockout | JRE custom tune
1100 - 1/30/18 | 2000 - 1/31/18
3000 - 2/06/18 TPW 2/26/18
3400 - 2/19/18 | 3800 - 2/26/18
4300 - 2/27/18 | 4B00 - 3/01/18
4200 - 3/05/18 | 4800 - 3/14/18
5000 - 3/16/18 | 6000 - 3/19/18
|