|
Just a few notes for those doing this.. If you have all the tools you can do this in <30 mins easy. You do not have to take the wheel off nor the front bumper.... unless you have huge forearms.
If you remove the upper bumper support, as mentioned you need to bend the hood latch back a bit, its a lot easier.
I used a step bit to drill the hole for the new emblem. I noticed it needs more cut off the bottom.
Jack up the passenger side tire.
Remove the bottom bolt. This is easier if you turn the wheel left.
Remove the next three holding in the liner (easier turning the wheel to the right)
The clip is connected vertically and plugs into the bottom of the "ballast".
The connector has a clip that needs to be pulled down, then the button will release the connector. Since the connector is the same as the one in the new glowtie harness, you can look at the one you're about to plug in as an example.
If you leave a light in the fenderwell you can easily see where the harness needs to feed.
Hope this helps!
|