The 3D Carbon fender vents are easy to install if you don't mind cutting into your car. I did mine with a cut off wheel on a angle grinder.. You just have to take your time so you don't melt the paint too bad. If I did them again I would use an air saw (I didn't have it at the time). Make sure you paint all the bare edges so it doesn't corrode. I also used a seam sealer around the inside of the whole vent to be safe.
__________________
CAI intake | OBX LT Headers | Flowmaster AT Exhaust | Trifecta Tune | SS Rear Diff, Axles & Driveshaft
Zex 100 Shot Nitrous | Konig Airstrike Wheels | Custom Engine Cover, Fuse Box & Underhood Bowtie
Eibach Springs & SS Sway Bars | BMR Strut Brace | Drake Shifter | Vitesse Paddles | 13.26 @ 105.88 mph
|