View Single Post
Old 10-01-2017, 01:10 PM   #3
exxit
 
Drives: 2016 1SS D1SC Methfed Lowered Wrapd
Join Date: Apr 2016
Location: CA
Posts: 632
Quote:
Originally Posted by Turbo_RORO View Post
I have this kit. It is well put together and of high quality. Here are a couple key notes I wish I would have done before or during my install:
- Make sure that you have little gas left in the tank or you will have more to drain.
- Also don't forget to order the tap also it is not included in the kit.
- Plus the sealer needs to setup over night so don't plan on driving it too soon. If you are like me
- The kit no longer uses the Warlbro pump. It has a Bosch 044.

Will this setup get you to "full E85"? I will say YES*

I have a cam with 32% lobe and all lt4 fuel system and I have run as high as 77% ethanol (highest I've ever gotten out of a pump) and the lowest fuel pressure I saw ( after changing info in the tune) was 65psi. Which is great.
I'm wondering if just the aux fuel system will cut it without a cam, high side, low side, injectors etc etc
__________________
//2016 1SS M6 D1SC Upgraded IC 4.25 Pulley//
// Alky Control Meth Kit running 100% methanol //
(purchased from JDP, installed by True Bliss Customs, tuned by NewEraPerformance in Augora Hills)
// 3M/Gotch Design Sponsored Gloss Deep Space Colorshift Wrap //
exxit is offline   Reply With Quote