|
I have looked quite a bit as of late and one guy did his own. It was done in a weaker section of the intake and in a way that it changes wiring routing and a bunch of other stuff.
But, there are no kits or pre-built units.
I have actually came up with a way to make it work, but to accomplish it in a "bulletproof" manner it is quite expensive and very involved to get "right".
I may do it as an exercise and a way to see if I can actually get max power out of a non-e85 setup on 93 octane, but I really shouldn't even need it with the proper parts (cam, turbo, intercooler, piping, etc). Problem is to pull it off looks to be around $1k in parts going progressive, direct-port, good controller, etc. I do have an extra intake manifold on hand to do the build.
If I do get a system done I might end up offering doing the build for a cost. As I stated it is quite involved compared to most setups.
|