Quote:
Originally Posted by Markoz28
Not to high Jack but where are you all mounting the Alky pump and tank? I would like to mount in the trunk.
|
The Alky kit uses the factory windshield tank - I am still working on the Alky install but I am very impressed by the quality of components and how well thought out it is.
If I had any complaints - it would be the instructions. They give you a set of pretty much text only instructions on about 10 pages of paper, most of which are 5th gen instructions adapted to the 6th gen. IE- they want you to mount two LED lights in the dash, with pictures of the 5th gen dash. Where they have the LEDs, there is no way they would work on the 6th.
The install is not for the faint of heart. Remove nose, passenger fender, modify tank, tap vacuum source, mount Alky MAP sensor, several electrical runs (MAP signal, 12V hot, 12V switched, tank sensor switch, remote unity, controller, and two LEDs), run pressure lines, mount new windshield tank, extend windshield lines, extend washer wiring (I am actually putting a 2qt washer tank in the trunk)