Advice for cutting valve covers
I'm doing a 2650R swap on my ZL1 and I don't have access to a bandsaw to cut the valve covers.
Any advice for something else I could use and not make a mess of it? What did other folks use to cut theirs?
I could buy a bandsaw but it would probably be the only time I ever use it. I also considered just buying new lower profile covers, but I was wanting to stick with the OEM baffling under the assumption it might be better than aftermarket (+ it's cheaper to keep them or buy a bandsaw).
Thanks
__________________
2017 ZL1 Black, A10
Build: Magnuson 2650R, 103NW Throttle Body, Rotofab Big Gulp, Kooks 2" headers, Catless, AWE Touring exhaust, JRE Smooth Idle Cam, Katech Oil Pump, Elite Catch Can, JMS Fuel Booster
|