View Single Post
Old 12-13-2017, 08:51 AM   #9
RXtacy
 
RXtacy's Avatar
 
Drives: 93 RX-7, 17 SS 1LE, 04 RX-8
Join Date: May 2017
Location: MD
Posts: 270
Quote:
Originally Posted by Tachitup View Post
Great DIY write-up > thanks for sharing. If you're going to us a hydraulic press to install the new studs, why not use the same hydraulic press to remove the old studs ? That way you're not hammering the crap out of the old stud and unnecessarily putting that hammering force on the wheel bearings.
You definitely could use the press to knock the studs out as well. I found them to knock out rather easily, so using the hammer was faster for me. The studs hardly even flattened at the end from the hammering so still perfectly usable.

Quote:
Originally Posted by PackersFan26 View Post
good quality how to. great job!
RXtacy is offline   Reply With Quote