I have a question for you all. Was the front endlink for the FE4 suspension upgraded from a 10mm to a 12mm?
If so, that's good because I have those endlinks at home. The only issue is that the mounting point/hole on my Pedders Xa coilovers is 10mm. This may be a dumb question, but what size hole do I need to drill? 12mm bit to enlarge the existing hole? I'd just like to double check prior to mistakenly making the hole too big. I would hate to have a rattle, etc.
Last edited by StlRomAniaN; 01-02-2021 at 08:21 PM.
|