[EDFHOBBIES]

It's me..

2 dive planes or kanards L & R
2 bezels L and R
1 lower spoiler or splitter
2 winglets on the end of splitter
1 upper grill
1 lower grill
Clips or plastic parts that push through to hold dive planes
6 screws to hold on winglets to end of spoiler
6 inserts called nuts but plastic inserts that push into lower splitter for the 6 bolts to attach winglets

Reuse your lower soft rubber parts on bottom of splitter. No need for a new one will need to drill old rivet from old one.

I gave my template to a friend for dive planes..

You also have a choice make a hole in fascia to attach the winglets into the fascia or trim tab off. The tab pushes through the fascia and same clips from dive planes hold it on.. I trimmed mine hit 150 many times no trunck failed or winglets failure yet.. was windy out to


I have extra set dive planes and some hard ware I'm not going to use.. I was going to cover mine in carbon fiber but not going to I am going to do mirrors in cf if I can find some cheaper than 150 used lol