Quote:
Originally Posted by donaldp
I installed these a couple weeks ago on my M6 "Rev Match" paddles but exactly the same application. It is so much easier than I expected.
1. Disconnect negative battery terminal and wait ten minutes
2. Insert small flat end screwdriver in each small hole on the side of the steering wheel and depress the spring loaded clip one at a time. This will release the airbag.
3. Pull the airbag forward but do not waste time/effort disconnecting any of the electrical connectors. just move it slightly out of the way with the slack in the wires.
4. Pull "fifty" badge off the bottom of the wheel or "SS" or whatever you have. This is clipped on.
5. Pull off the one piece bezel that houses both sets of steering wheel buttons and just move slightly out of the way. This is clipped on
6. Disconnect tiny electrical connectors to each paddle and remove one torque screw on each side.
7. Install red paddles and everything else in reverse order.
8. 15 minutes total after waiting 10 minutes after disconnecting the negative terminal
|
Dude!!!! Thank you so much for taking the time out of your night to write this! I truly appreciate it!! I’ll do the same tomorrow and post pics! Seriously this is what the forums are for! I appreciate it and hope I can help you in the future with something!