CAMARO6 - View Single Post - Just to verify...Borla 60606 to stock NPP. 60606 CEL?

JayhawkSS1LE · 10-31-2017, 09:35 AM

I have a Borla 60606 that I am connecting to the stock NPP.

The 60606 does not have the cutting instructions, however the Borla S-Type/ATAK instructions say to measure out 7" to make the cut.

Just want to verify that is where I would still make the cut to attach the 60606? (It's just kind of reversed, not replacing the axle back, I am replacing the mid.)

Lastly, as long as everything is buckled up tight, I shouldnt get a CEL from the 60606 should I? Anyone receive one from the 60606?

Thanks

10-31-2017, 09:35 AM	#1
JayhawkSS1LE Drives: 2017 SS 1LE Join Date: Jun 2017 Location: Woodstock, GA Posts: 200	Just to verify...Borla 60606 to stock NPP. 60606 CEL? I have a Borla 60606 that I am connecting to the stock NPP. The 60606 does not have the cutting instructions, however the Borla S-Type/ATAK instructions say to measure out 7" to make the cut. Just want to verify that is where I would still make the cut to attach the 60606? (It's just kind of reversed, not replacing the axle back, I am replacing the mid.) Lastly, as long as everything is buckled up tight, I shouldnt get a CEL from the 60606 should I? Anyone receive one from the 60606? Thanks __________________ 17 SS 1LE.