[Eric SS]

Originally Posted by camaro5

I had seen this version posted in another thread.

They actually specify loctite only for the rear links.

Neverless, loctite may help, and for more durability, add Nordlock washers.

It's with the ELK015 - Sway Bar End Link Kit, Set Of 4, Adjustable


Install the BMR end link as shown in IMAGE 2. The offset
bushing should have the narrow side closest to the outer
knuckle. Tighten the nuts on the sway bar side using a 17mm
wrench. If the entire shaft spins while tightening, use a 14mm
wrench to hold the base of the shaft while tightening the nut.
14. Insert the provided 10mm x 60mm bolt and washer into the
lower bushing of the end link and tighten using a 17mm wrench. NOTE: Blue Loctite is recommended
on this bolt. Torque to 33 ft/lbs.

https://www.bmrsuspension.com/index....productid=1611

I did make sure to use Loctite on the rears as outlined. If they loosen again I'll put a little dab on the fronts as well.

EDIT: On a side note, stupid me installed the rear end links with the grease nipple facing the knuckle so I couldn't grease them so I had to take it apart and swap sides. lol.