Quote:
Originally Posted by sracer
I just finished up the install - loving it.
I'm in the Phoenix area and want to run cooler so was looking at the AEM kit. I saw your other post about running AEM meth injection. I don't need extra HP (for now ), but is there a "minimum" configuration so I can get the cooling and intake cleaning effect, but not go through a tune? Thanks!
|
SC install looks great!
You sure can, if it's warm enough year round where you live, stay toward a straight water mixture in the tank so it won't have a big effect on your A/F ratio, but it's probably easiest to just use the -20 windshield washer fluid. If you do, stick with the cheap stuff, read the ingredients which should be only water, methanol and dye, and finally shake the bottle, if the bubbles disappear in a couple seconds it's probably the right stuff.
I'd install the AEM 30-3350 (with tank) or 30-3352 (no tank). Since I used the stock windshield washer tank we didn't need the tank. I will note that the Camaro WW tank does not have a level sensor, so I recommend adding a level sensor to the tank, or using the AEM tank.
Drive the 30-3350 controller off the MAF sensor - its the light green/white trace wire on the 8 wire MAF that you connect the blue AEM wire to.
Run the medium size nozzle (500cc/min), test the system as outlined in the instructions before installing the nozzle in the intake and you should be ready to go.
I just did the install on my Z06 last weekend, I should have taken pictures along the way which would probably been helpful for the install...