Quote:
Originally Posted by bub
To others out there not familiar with adding these wiring connectors to a harness, buy extras. Took me 4 or 5 shots a piece to do these last time I used them.  Small and fiddly and we do not have the special jig/crimping tool and connector insertion tool that would probably make them go easier....
Leave the wire long and make the term with the wire slid thru and past the connector (with the PTM lock removed to permit this reverse assembly) and "pull" the connector back into the harness plug. Couldn't "push" mine in after crimping and could only "pull" them in backwards per say...
Related post I made on making up these little pin connectors (for custom illuminated door sill harness)...
http://www.camaro6.com/forums/showpo...3&postcount=28 |
Great advise. Mind if I copy some of that to include in the write up?
I haven't played with them either and used some that were close but did have connection issue. There is a few others I didn't post and one I just can't seem to find. My should arrive Tuesday. I leave for OK Sunday. 😠