|
My 2SS HVAC bezel and controls showed up yesterday from the Topeka junkyard. Haven't even had a chance to open the box yet tho.
Thinking this out...with the 2SS HVAC module and with 2SS HVAC controls, the HVAC blower speed will now be controlled by the fan up down switch between the vents (as well as auto when auto control is engaged), right?
Assume that the right vent ring will be dead as dual climate is not active, and it doesn't run the fan in the 2SS system, but numbers in RH passenger temp display will (artificially) show passenger set point temperature in degrees?
Might be possible to put a small swatch of black electrical tape over the display (out of obvious site slid behind the plexiglass) so no numbers show in the RH display?
|