[glamcem]

Originally Posted by vtirocz

The zip tie gave me ~1" of minimum clearance after everything settled (checked a week later). I still didn't like that. I ended up removing the zip tie and routing it the same a pic2 in this post and now have a few inches of clearance:

http://www.camaro6.com/forums/showpo...0&postcount=76

I unplugged the the connector with the gray/red wires and routed it behind the other portion of harness and plugged it back in. That has to be the way it was designed to be from the beginning. It didn't feel like there was any excessive tension anywhere that I could tell after rerouting it.

Big thanks to glamcem, DenverTaco07, and everyone else that helped figure this one out!!!

Originally Posted by TimsZ28

Thanks for the post. I am a fortunate one. Plenty of clearance at 22k miles so far. Never hurts to check though.

Originally Posted by MAGAUSA

What is your build date? My 12/16 build doesn't have any electrical harnesses or wiring near where this could happen. By the way, your flywheel/harmonic balancer (whatever GM calls it) looks great. My has rust spots already being here in Florida.

It is 11/16