[KyleL]

I noticed in all your runs you used lc and came out about 3600. I'm curious though, what was your slip target, did you try other rpms to launch from, did you dump the clutch on lc and rely on the computer or did you try to feather it any and did you try to utilize the no lift shift feature? Based on the pdr footage, you lifted and I'm curious that if you made a run without lifting if it made a difference? I apologize if you answered these questions already, I just didn't see by skimming the thread.

I've noticed that with anything less that a 10% slip target and under a 3500 rpm launch on an unprepped surface, there's too much interference and the car just falls down, THEN chirps through 1st much like your car did. Did you try just maxing the parameters out (4000 rpm launch with a 15% slip target) to see what that'll net? If so, what results did you get?