Here's what I will be going with
Vertini / Stance Wheels FULLY FORGED aluminum wheels
19x 10" fronts, 19x 11" rears
semi gloss black with ceramic coating
22.6 and 23.0 lbs, front and rear respectively
saving
7 lbs per corner... total weight savings of
28 lbs unsprung rotating mass...
should translate into roughly an 84 lb trim of the car's inertia...
with the removal of the back seats... that puts me at
100 lbs of felt weight savings...
Most likely an aluminum drive shaft next which will save a further 8-10 lbs and approximately 30 lbs of inertia due to its rotating mass. (might also help with engine rev and and spin up)
the best part will be the fact that my car should be arriving sometime in March... which is right around when the new
Michellin Pilot Sport 4 S tires...
285/35R19 and 305/35R19 most likely....
http://blog.caranddriver.com/micheli...lot-sport-4-s/
