Quote:
Originally Posted by BradfordCamaro
I will be over when the snow is gone with 24 beer and My BTR Cam. How does that sound?  |
Yep, I think when the scare value wears off, people will figure dropping the pan adds 1.5 to 2 hours to the job. I figure 3.5 hours for headers, 3 hours for the heads, 3.5 hours for the cam. 1.5 hours for grins = 11.5 bookable hours. I would expect $1000 to $1500 install quotes when the fear dies down. I would expect many people DIY.
Plus I may add IMO the CNC heads from most people are too big for the 220 duration .560 lift cams I'm looking at. Even that said, the local vendor (Texas Speed) offers CNC heads and 5 angle valve job for $900 exchange!
__________________
Forged short block, large duration sub .600 lift Cam Motion cam, 7200 RPM fuel cut, Pray Ported Heads, 3.85 pulley D1X, stage II intercooler, DSX secondary low side, DSX E85 sensor, Lingenfelter big bore 2.0 pump, ported front cats, 60608 Borla, LT4 injectors, ZL1 1LE driveshaft and Katech ported TB, ported MSD intake, BTR valvetrain, ARP studs, ProFlow valves, PS4 tires.
|