Quick update...
All but one kit ordered during the pre-order phase will go out tomorrow. I apologize for the one kit not making it out. I ran short of the wire loom and will have more in hand on Wednesday. This loom is really nice and I don't want to substitute anything else in its place. I will get that order out as soon as the wire loom arrives.
Here is the final configuration...
I will try to have an installation guide put together before the kits arrive in your hands. If for some reason I miss that deadline I will be more than happy to help you through the installation process. I am doing an electrical test (using my scope) with the sensor plugged in to the harness to verify operation before they go into the box.
As I stated in an earlier post I've pre-tightened the AN fittings. You will see silver markings on the fittings that should be in alignment with each other. If they are not in alignment the fittings should be loosened and retightened. The markings can be removed if you wish. I cannot stress this enough... PLEASE triple check for fuel leaks before deeming the job complete. If you have any issues or concerns during the install please call or e-mail me.
Thanks to everyone that ordered the kit and to everyone that has been supportive!
Tim