Quote:
Originally Posted by TSloper
If you have your dyno torque curve I can give you the proper shift points. I created a Matlab script to calculate them for each gear based on the TQ curve.
If you have the actual Dynojet file (assuming Dynojet was used) it will calculate them in about 3 seconds.
Tim
|
Thank you, appreciate the offer.
I do have them. Unfortunately it appears I only have the one from before the heaaders were installed. The other runs don't appear to be on the drive. Will that work? The difference was about 35 HP. I can also go get a copy from the shop tomorrow...
I PM'd you a link. Thanks again.
Chris