For anyone concerned about the MAF changes when switching to our CAI,
A very knowledgeable forum member purchased our CAI and did extensive data logging over the weekend. He had this to say about the Roto-fab system:
"Quick update... I will post specifics later tonite.
So I would like to say great job to Rotofab. I am very impressed with not only the construction quality of their intake I am impressed at how accurate they kept the MAF output. The variation on AFR was sub 1% across the RPM band. This was data collected in MAF only mode in the ECM which really isolates the AFR from being influenced by other variables. I did 3rd gear runs (A8) from 1500 RPMs up to redline. The stock vs RF runs were within a couple hours of each other with minimal weather variation.
On the power front I was not on a dyno today but the one area that hints at a definite improvement is the MAP. I stays about 1 kPa higher across the RPM range over the stock intake. So as of right now I do expect to see a power increase of some level on the dyno."
Link to Tsloper's review thread here:
http://www.camaro6.com/forums/showthread.php?t=465449
Thanks everyone for your interest and support!
Michael