[Hyper1SS]

Just got done with our install before the storms hit. I want to Thank my son Dakota for helping with this install. Roto-Fab included detailed instructions with full color pictures to help with the install. Taking the OEM intake air system out and installing the Roto-Fab unit was a piece of cake. Make sure that if you want to do the badge plate flip and install the red Roto-Fab decal you do it before you start anything else. Like it says in the instruction make sure to build the MAF tube, plate and air box first before putting it in the car other wise it will be more of a pain to do it then. Once the box is in and you have everything else done besides the elbow make sure you cover your radiator area with a towel because Roto-Fab uses every inch that they can and it is tight getting it into the two boots so you don't want to scratch up your new intake tube. Once I had everything installed and before I tightened down on the clamps I made sure everything was seated properly and fully. Make sure once the Filter is put into place and tightened that it is at a slight angle forward like in the picture and runs even with the ledge built into the box for it to sit on. Ok now when tightening the clamps on the elbow make sure it is fully seated into both boots and when doing so make sure you do not push down on the elbow because that will cause the box at the fender where it is seated fully into the grommet to raise and that will throw things off and that could cause your hood to raise slightly on that end when hood is shut leaving it misaligned with the front bumper cover and the fender like I had read in another post from yesterday when someone installed theirs. My final thoughts are WOW!!! This could air intake is amazing, huge and looks awesome in the engine compartment of the Gen6. They used every inch possible side to side and from top to bottom. From the time I got my intake delivered in the box to my install I was totally pleased with the efforts Roto-Fab put into packaging, instructions and the overall quality in the build and parts of their cold air intake!!! Thank you Roto-Fab for a great cold air intake