|
Again, thanks for your input Speedy.
Just got a response back from Edelbrock. (Man, they are quick to respond!) They stated they have seen this kind of MAP over-response before on another setup. The solution was to add in an orifice to the actuator hose to soften the vacuum signal. Makes sense. An orifice should be on its way soon from Edelbrock.
As for the high IAT's and cooling; I may try either Water Wetter or Evans Cooling first and see if that helps. A larger heat exchanger may be an option also. I may also try a cooler thermostat. I know It won't help much, but might make me feel better. My only concern about adding in a lower range thermostat is if it will it keep me in warm-up/open loop mode if I don't hit the operating temp the ECM is expecting. Regardless, some improvements on overall heat rejection seem to be in order.
|