[cellsafemode]

Well, a solution is going to require either a significant amount of replacement parts or some not so pretty tube attachments - maybe this is what is holding up solutions?

The hard line tubes can't be removed from their connectors. So that means cutting them in the middle and squeezing some flexible hose over the hard tube and clamping or cutting the hose at the fitting and leaving what remains of the hose on the fitting and putting your hose attachment over that and clamping (this is what i did).

If I need to add a 3rd hose tap from the driver side intake tube supposedly going to the "dirty" side of the pcv system then that's gonna be a fun looking connection.


the tapping of vacuum hoses and adding one way check valves etc sounds unnecessarily complicated. It may be an improvement, may not...but none of that should be necessary to eliminate what is already making it's way into the intake.