View Single Post
Old 07-14-2016, 05:56 PM   #1
jessrayo
Speed Freak
 
jessrayo's Avatar
 
Drives: 2013 ZL1 Camaro, 2016 Camaro SS
Join Date: Jun 2013
Location: Ardmore, OK
Posts: 2,637
Dyno results - AGP twin turbo 2016 Camaro SS

I've been a little slow on posting all of the results of my build. I have put about 3500 miles on the car with the turbos and really like the way the car performs. I have a pair of Borg Warner EFR 7163's with the .85 A/R V band housing. The car has a methanol injection system spraying two nozzles directly into the intercooler when boost is above 6 psi.

Dyno graph is pretty self explanatory. 3 runs, bottom was totally stock. Middle was max power we could get with totally stock fuel system. Top graph is max power with tank fuel pump upgrade. Power is still limited by fuel pressure to the injectors and will need the secondary camshaft pump upgrade to make more power.




It drives so well now that I may not make the additional cam pump upgrade. Right now on the stock tires with the traction control on I can just hammer it and as long as the road is dry it is stupid fast but controllable. No wheel spin with 60-70 mph roll-ons and the fishtailing from a dead stop is pretty minor with the traction control in stock setting. It is a fast but driveable street car.
Attached Images
 
__________________
2016 SS -AGP twin Borg Warner 7163 EFR's, LT4 mechanical pump, LT4 injectors, Walbro 255 low side, Castrol SRF. 734whp/759 tq

2013 ZL1 -ADM - 427 LSX 6 bolt, O-ringed block built by LME. Twin PT6466 turbos. RPM custom manual trans, RPS Quad carbon clutch, 9" Hendrix rear diff & axles. ADM/squash fuel system, Ron Davis radiator, Spal fans, AGP air to air, turbo plumbing. LPE oil cooler, rear bushing upgrade, roll bar...etc. rwhp 1400+... 212.5mph, best Texas mile to date.
jessrayo is offline   Reply With Quote