Thanks again to Chris!
so using this image....
I want to put a side stripe near the door to accentuate the black n' yellow theme...
while I like the Camaro Perforance Concept.... I think a curving decal would look best because it will mirror the blacked out side windows....
how the side windows curve down in front and then curve up at the back...
so I want the front of the door stripe to follow the downwards curve of the door contours to end at a point just shy of the bottom of the front wheel arch (while still leaving the bottom line of yellow to preserved the yellow car outline), while the back end of the stripe should curve up to fill in the natural upwards contour of the side profile
The curve at the front follows the natural curve which start above the contour line... meaning half of the curve is still yellow, transitioning to black below that line.
The curve at the back will mirror the curve above the line, ending like a spear point , with the top half yellow and the bottom half black.
Too many words and not enough diagrams... I hope I have been clear...
TO clarify, there should be a little bit of curving decal just AFTER the door frame to curve up to a point where the straight pronounced door countour line ends....
rear should have this curve ( with straight edge)
front should be this curved point rotated 180*
also at the back.... I wanted another stripe on the side bumper that start with a curve following the rear wheel well ( leaving some yellow there) and ending just before the end of the side bumper ( again leaving a borderof yellow to keep the yellow silhouette)
Blacked out mirrors while keeping the stalks yellow to keep the black silhouette of the windows intact.
Blacked out sharkfin.
Heavy tinted tail lights
Thanks again, I think this will be my final draft before going to the detailers with this....