[db2022cs]

So, I got under the car today to just look at as many wires or connections as I could. As I got under there, the first connection I looked at, right where I think this goes into the NPP valve, there is a partially melted wire and I can see that it may have gone through to the metal in the wire. Is this a possible cause of my issue? Even though it is at the NPP which still has full function, I assume that the CAN bus network could have issues with communication integrity being affected thus a lot of modules are coming back with intermittent communication loss. I will have the shop I go to Wednesday look at it, I will also look at replacing this if it's possible. I think it might just be an extension. The shop that installed my aftermarket Corsa exhaust did not take the proper precaution getting that harness off the hot exhaust.