CAMARO6 - View Single Post - New 2023 ZL1 should I change out parts already?

2023_ZL1-AUTO · 03-22-2026, 06:15 PM

Update #1: Made a lot of progress this weekend. But OMG am I beat! Parachute Kit and Fire suppression kit are 100% installed (minus 2 brackets I'm going to make to hold the nozzles in the engine bay. Rear Seat Delete is installed once again and center console is in place but there is a wire harness connector I can't figure out where it goes. It's connected the the harness that's attached to the under side of the center console, so it must connect somewhere to the car under the console? But, I can find a connector or another wire to connected it too anywhere (I included a photo of it). I've had my console out at minimum 5 times in the past and don't remember this wire. I always remember 3 connectors. The wireless phone charger USB connector, the larger and smaller connectors located about the center of the trans/driveshaft tunnel. Maybe it's for an option my car doesn't have (But I don't think they do that) and therefore connects to nothing? In the photo the console is upside down and the view is looking into the under side.

03-22-2026, 06:15 PM	#801
2023_ZL1-AUTO Drives: 2023 ZL1 - Beast Build Join Date: Dec 2022 Location: Columbus, Ohio Posts: 1,264	Update #1: Made a lot of progress this weekend. But OMG am I beat! Parachute Kit and Fire suppression kit are 100% installed (minus 2 brackets I'm going to make to hold the nozzles in the engine bay. Rear Seat Delete is installed once again and center console is in place but there is a wire harness connector I can't figure out where it goes. It's connected the the harness that's attached to the under side of the center console, so it must connect somewhere to the car under the console? But, I can find a connector or another wire to connected it too anywhere (I included a photo of it). I've had my console out at minimum 5 times in the past and don't remember this wire. I always remember 3 connectors. The wireless phone charger USB connector, the larger and smaller connectors located about the center of the trans/driveshaft tunnel. Maybe it's for an option my car doesn't have (But I don't think they do that) and therefore connects to nothing? In the photo the console is upside down and the view is looking into the under side. Attached Images __________________ Katech Track Day CAM 38%•BTR Dual Valve Springs-Johnson Lifters•Trend 3/8 Chromoly Pushrods• VVT Del•CNC Ported Heads•AFM Delete• C5-R Timing Chain•Katech Oil Pump•Katech 112mm•Maggie 2650 3.25” Upper & ATI SD w/10.32” +20%•10 Rib Belt•RFBG•FI Interchiller Stage 2•THPSI Port w/875cc Inj•Dual Drop In Fuel Pump•DSX Aux Pump•Stainless Works 2" w/Legend NPP Axle Back•GESI UHO 4.5" CATs•Brisk RR14S Plugs•BMR Motor Mounts•BMR Cradle Lockout/Bushings Kit•DSS Chromoly DS•RPM 8-Point Roll Cage•10lb FireSense+ w/4Fire SFI 17.1 Fire Sys•Weld Forged Vitesse Rear 17x10 Beadlocks-Front 18x6•Unlocked TCM Last edited by 2023_ZL1-AUTO; 03-23-2026 at 03:57 AM.