Quote:
Originally Posted by Sillysspeed
So I got all the parts to put the lt2 manifold in and got it installed this eve. I actually used some 10” high leverage knipex cutters to trim the underneath plastic. Worked better than the burr bit IMO. Installed brake booster fitting with a good amount of thread tape. Ict map extension you really had to use some pressure to get clipped. Trimmed the sound deadener underneath the manifold to fit and re installed the stock throttle body. There was already oil in the intake. Car only has 650 miles on it. So I installed the might mouse can also. Slight pita to install but it went on eventually after trying to fight me. Went out to Mexico afterwards to see if I could notice a difference in performance. I was rewarded with a new best slip. I made 3 passes this one being the best. All similar tho. Air was -40da. Last time out was 120+da so pretty similar. The dragy is always off on da and elevation. Car just continues to impress me.
|
How much pressure to get the map sensor harness connected? I'm pretty strong and gave it all.I have and it won't connect. I have removed the seal and sanded some of the plastic down, and it still won't connect. It's the harness from g p I.