|
I know this is an older post, just in case people are searching. I put on a set today and the run out was within spec of .0004 and thickness tolerance within the .0002. Words of wisdom you need two hardware packs, those packs each cost $100. I have Tyler overnighting the second set so I can finish up tomorrow. The one PIA is the coating on the rotors, glad I had enough brake cleaner and used a green scotch pad to get the coating off. Hardware looked better than the OEM matched the OEM and I like the idea of everything being stainless. Get the second one on then bed in the rotors and see how that goes. More follow ups after a Mid Ohio and NCM date over the next couple weeks. Put on a new set of GLoc R12.
|