|
This is a great topic that I plan to do more testing on specific to the LT4. I think common logic understands that faster is not better past a certain point (undefined currently). I think it's clear that the most effective "cooling mods" are the ones that add capacity and surface area. Even at the same flow rate, there will be better heat transfer. too slow of a coolant flow will prevent efficient BTU transfer.... but too fast will also. There is a sweet spot which I believe is currently undefined. My guess is that it's somewhere between 5-6 GPM. Here is a clip from the flex-a-lite;
"Faster is not better when it comes to engine coolant flow rate. The purpose of a radiator is to support heat transfer, which is a time-dependent process. As Flex-a-Lite explains, to move the heat from one medium to another (engine to coolant to radiator to atmosphere), the coolant has to remain in contact with a surface for heat transfer to take place. Moving fluid too quickly through an area can result in laminar flow, where the fluid forms layers. The layer closest to the surface moves slower than layers farther away from the surface. When this occurs, the layers act as insulators and the capacity to transfer heat is diminished"
I am not sharing this to say that the CWA150 is not a beneficial modification... I do not know yet, and have not tested it yet on our system, but I have one, and plan to test more to measure flow, and pressure changes... as well as real world IAT.3 temps. Just wanted to contribute to the conversation.... and would love to see your GPM flow rate, although I know purchasing and installing the flow meter is very inconvenient. I will, and will share my data.
|