[Speedspeedspeed]

I’m sure there’s been threads on this but I can’t seem to find the answer I’m looking for.

I need some help with the installation. I got the stock header and cat out on the drivers side. I’m trying to slide the headers up from under the car but it’s not fitting. I’m pretty sure I need to loosen the motor mount and lift the engine slightly higher to slide the header in place. So with this being said I have a few questions:

1. Has anyone installed it without lifting the engine? Has anyone been able to slip it into place from the top of the engine?
2. I need some help locating the motor mount. I attached some pictures. Is the circled bolt the one I need to loosen? If not any pictures would be great.
3. Where is the proper location to lift the engine? I plan to use a jack. Can I lift the engine from the oil pan? I would use a hockey puck to cushion it.

Any help would be great! Thanks!