Quote:
Originally Posted by dfxrte
can't start until the code is put in. installer may have botched the install or it wasn't a manual
source: i have one
|
Thanks DFXRTE. I do know that his is a manual transmission. The installer tried two different IGLA units and even updated the firmware to try and get it to work. But, the Z would start like normal, but would stall out if you tried to drive away then hit the brake. They spent two full days trying to figure out how to change the programming to “not start” until the code was entered. They basically succumbed to the fact that they couldn’t do it and the decision was made to just remove it. The whole idea was to not let the engine start until the code was entered, but that didn’t work out. It’s a HUGE bummer as this system looks bulletproof, even for advanced thieves. And yes, I know anything is steal able, no sense in rehashing that again. Thanks again