Quote:
Originally Posted by arpad_m
Did you apply threadlocker to the caliper bolts? Also, what torque did you tighten them to (the spec calls for 111 lb-ft initial + 15-30° final pass if I remember correctly)?
I also have SS 1LE brakes, and they exhibit no vibration at all even, whether it's light or even emergency braking, after several rotor and pad changes. If the bolts are tight and your rotor looks fine, you could indeed try re-bedding the pads.
|
I had a shop do the work so not sure what torque they went with. This was a different shop than the original shop as well. They did tell me all the bolts all the way around were loose but the first shop could have not tightened them fully. Not sure what's going on.
I'm going to go ahead and remove the wheels tomorrow and check the calipers to make sure they're tight again. I couldn't get a turn on them last time I checked which was about 3 days ago.