Thread: Eliminate rasp
View Single Post
Old 03-11-2024, 03:15 PM   #12
FlukeSS

 
FlukeSS's Avatar
 
Drives: 2020 Camaro 2SS A10
Join Date: Jun 2018
Location: Here
Posts: 1,841
I'll say it then.

2" LT headers, no cats, 3" X-pipe (stock is 2.75), stock axle-back



Added MBRP axle-back + Cam



No you won't chop like I do, but MBRP will lower the tone.

All the rasp is mostly in the Axle-back maybe a small part of it in the x-pipe.

With my setup its basically straight piped. And it is loud compared to stock suit case.

Sound at near WOT again remember I have a cam. Also remember soon as you dump the stock suit case you are likely to get some drone. My car does have drone, more of a buzzing sound at cruising speeds. Some people hate it, it doesn't bother me anymore, it did at first until I got used to it. That said I attribute the buzzing sound to the cam, and trans tune that I have. The axle-back makes it more obvious than it would with the stock suit case still on.

__________________
2020 Camaro 2SS A10 | Rebuilt by: CBI Street Cars | 2" SE LT Headers | 3" SE X-Pipe | 3" MBRP Axle-Back | Pri & Sec Cat Deletes | Roto-Fab CAI | LT2 Ported | 95mm ZR1 TB | LSA crankshaft conversion w/modified crank gear | LS1 thrust bearing | Gen V Hinson Plug Wire Set | BTR 220 Stage I Cam | ARP Rod Bolts | Delphi Lifter set | NGK LTR6IX-11 spark plug set | DOD Delete | VVT Limiter | ECM, TCM & E85 | Retuned by: Justin L. | Dyno: 510 rwhp 472 rwtq | Best 1/4 Time: 11.639

Last edited by FlukeSS; 03-11-2024 at 03:26 PM.
FlukeSS is offline   Reply With Quote