|
Just posting this in case it helps anyone or saves them some time.
I reached out to the OP and he stated that when torquing the bolts, one was over-torqed and it broke or cracked the weld nut. He ended up getting a longer bolt and putting a physical nut on the end of that bolt and tightened it which resolved the issue.
In my case.. im not sure if i was just tired or what b/c i did the install by myself ...but my steering was loose b/c i installed one of the intermediate shaft bolts upside down (duh). Removed the bolt and reinstalled from the other side and torqued to spec... issue was resolved.
This I was an easy enough fix so I hope it saves anyone in the future a little time that may have the same issue.
|