Quote:
Originally Posted by cjperformance
I'd probably wait until you have everything in front of you before trying to make the fuel lines.
The fittings aren't really reusable once you've tightened them down on the fuel line. Sure you can probably "get away with it" if you make one wrong, but fuel's no joke... and those things are expensive if you make one or more of them a little too short or long.
So if it were me, I wouldn't pre-assemble anything. Even as little as a 1/2" off in length can be a big problem.
I didn't record the lengths on mine or I'd give them to you, and given that a minor variance can be a problem, i doubt I'd be able to get you completely accurate lengths if i went out and tried to use a tapemeasure or something.
|
All the fittings I had were reuseable, just don't over tighten them. Mike actually built mine that's in the picture and shipped it to me unassembled, I put it all back together at least twice, once with the original blower and after it was rebuilt at SCOL I put it back together again. Maybe you bought different fittings then I had, not sure why you think they can't be used again.